Evco EPV4CBR Hardware manual Manuel d'utilisateur télécharger pdf (Page 17)

EVCO S.p.A. Vcolor | Hardware manual ver. 1.0 | Code 144VCOE104

page 17 of 38

6 PRELIMINARY INFORMATION

6.1 Switching on/off the device

To switch on the device, operate as follows:

1. Connect the power supply: i twill be started an

internal test.

The test takes typically a few seconds.

2. To the end of the internal test press and release

the area in the bottom right-hand corner of the

display: the display will show the sensitive areas.

To switch off the device, operate as follows:

3. Switch off the power supply.

6.2 Access to the menu “Info”,

“Diagnostic” and “Debug”

To gain access to the menu “Info”, “Diagnostic” and “Debug”,

operate as follows:

1. Switch on the device and show the sensitive

areas; look at paragraph 6.1 “Switching on/off the

device”.

2. Press and release the area “USER”: the display will

show the menu “Network Status(CAN)”.

3. Press and release the area “ENTER”: the display

will show the menu “V-COLOR PROG”.

4. Press and release the area “DOWN” to select the

menu (for example to select the menu

“Diagnostic”).

5. Press and release the area “ENTER”.

To quit the procedure, operate as follows:

6. Press and release over and over again the area

“ESCAPE”.

Showing the sensitive areas

Selecting the menu “Diagnostic”

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 37 38

Pas de commentaire

Evco EPV4CBR Hardware manual Manuel d'utilisateur Page 17