Evco EPV4CBR Hardware manual Manuel d'utilisateur télécharger pdf (Page 13)

EVCO S.p.A. Vcolor | Hardware manual ver. 1.0 | Code 144VCOE104

page 13 of 38

3.7 Additional information for wiring diagram

- do not operate on the terminal blocks with electrical or pneumatic screwers

- if the device has been moved from a cold location to a warm one, the humidity could condense on the inside; wait about an

hour before powering it

- test the working power supply voltage, working electrical frequency and working electrical power of the device; they must

correspond with the local power supply; look at chapter 10 “TECHNICAL DATA”.

- disconnect the local power supply before servicing the device

- connect the device to a RS-485 network with MODBUS communication protocol using a twisted pair

- connect the device to a CAN network with CANBUS communication protocol using a twisted pair

- connect the power cables the most possible away from the signal’s ones

- for repairs and information on the device please contact the EVCO’s sales network.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 37 38

Pas de commentaire

Evco EPV4CBR Hardware manual Manuel d'utilisateur Page 13