Evco EPK4LHX Hardware manual Manuel d'utilisateur télécharger pdf (Page 16)

EVCO S.p.A. c-pro 3 NODE kilo | Hardware manual ver. 1.0 | Code 114CP3NKE104

page 16 of 44

4.8 Example of electric connection

The following drawing shows and example of the electric connection of the devices.

4.9 Warnings for the electric connection

- do not use electric or pneumatic screwdrivers on the device terminal board

if the device has been taken from a cold to hot place, humidity could condense inside; wait about 1 hour before powering it

make sure that the power supply voltage, the frequency and the operational electric power of the device, correspond with

those of the local power supply; see chapter 8 “TECHNICAL DATA”

disconnect the device power supply before proceeding with any type of maintenance

connect the device to a RS-485 network using a twisted pair

connect the device to a CAN network using a twisted pair

position the power cables as far away as possible from the signal cables

do not use the device as a safety device

for repairs and information regarding the device, contact the EVCO sales network.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 43 44

Pas de commentaire

Evco EPK4LHX Hardware manual Manuel d'utilisateur Page 16